How to beautify caps and hats

The Product beautifier turns your own photos of a cap, beanie or hat into clean e-commerce packshots, from the angle you choose. The headwear is shown brand new: crown fully rounded, panels smooth, with no creases, dents or signs of wear from the photos.

The eight angle shots

Right and left always mean the way the brim points in the image.

• Three quarter right — turned about 45°, the brim points toward the right and toward you; you see the front and the headwear’s own right side.
• Front — straight on, the brim pointing at you.
• Three quarter left — turned about 45°, the brim points toward the left and toward you; you see the front and the headwear’s own left side.
• Back — straight on from behind, the closure centered.
• Side right — a pure profile, the brim pointing to the right edge.
• Side left — a pure profile, the brim pointing to the left edge.
• Top — seen from above the front, looking down onto the crown, the brim at the bottom of the image.
• Under the brim — a close-up from below: the underside of the brim fills most of the image, with only a strip of the sweatband and the inside of the crown above it, cut off by the top edge.

You can select several angle shots in one generation: each product gets one image per angle shot.

Which photos to upload

Veeton gives the AI every photo of the product at once, so the more sides you show, the more faithful each angle is. For the best results, upload for each product:

• a front photo,
• a back photo,
• one photo of each side,
• a photo of the underside, if you want Under the brim.

Phone photos on a desk are fine: the background, your hands and any creases are removed. A side that no photo shows is guessed from the other side, without its logos or patches — so a logo that only sits on one side appears only if a photo shows it. When a selected product has a single photo, the setup panel reminds you that results are best with several.

How to generate

1. In the sidebar, open Studio and click Product beautifier.
2. When Veeton asks “What are we beautifying today?”, pick Headwear.
3. Select your products — several at once if you like.
4. Pick one or more angle shots. If you pick none, Veeton keeps the angle of your front photo.
5. Choose a background, then click Generate.

Each beautified image costs 10 credits.

Good to know

• Product beautifier margins apply to every angle shot. On Under the brim, only the horizontal margin applies: its framing from top to bottom is fixed.